You can click the 'two arrows' icon on each filter node on the canvas to create a parallel route through the pipeline. You can create either a Simple or Regex Filter using Add Process. The position of the new process/filter will be parallel to the existing route.
When you complete the filter details (simple or regex), you will see that the process/filter still has the orange icon . This is because it is not connected to anything on its right. The stray link must be dragged to another filter or to the Target to complete the pipeline.
You can add filters at every icon or parallel link icon. You cannot add a filter at a stray link until it is connected to a Target or another Filter. See the example below.
At the end, all routes through the pipeline must be able to send data to the Target or else the Target will not be marked as complete. Here the FindInvalidHeadOfficeItems filter is pulled to join to the Target:
Use the buttons on the bottom right to 'zoom in' or 'zoom out' to view the pipeline as you want, or to reset the view to the default ‘zoom’ level.
- Click the Save button to save the pipeline.
- Click the Exit button to return to the IBM i configuration tool. You must restart the Ironstream Hub service to implement your changes. The requirement to do this will be addressed in a future update to the Hub.Note: If you click the Exit button and the changes are not saved, it will prompt you to save or lose your changes.
You cannot save an incomplete pipeline. Save button will be disabled if the pipeline is invalid.
It is possible at this time to end up with stray links between the nodes. You may have to delete and add other nodes again to return the pipeline to the topology you want. This is intended to be addressed in a future version of the Hub.