For an application group, a procedure for only one operation (start, end, or switch) can run at a time. For information about parameters and shipped procedures, see What is started by the default START procedure for an application group and Choices when starting or ending an application group.
To start an application group, do the following:
-
From the Work with Application Groups display, type 9 (Start) next to the application group you want and press F4 (Prompt).
-
Verify that the values you want are specified for Resource groups and Data resource group entry.
-
If you are starting after addressing problems with the previous start request, specify the value you want for Begin at step. Be certain that you understand the effect the value you specify will have on your environment.
-
Press Enter.
-
The Procedure prompt appears. Do one of the following:
-
To use the default start procedure, press Enter.
-
To use a different start procedure for the application group, specify its name. Then press Enter.
-