The Change Message Control for Trillium activity allows you to customize the severity of specific error messages returned by the TS Connector under both batch (Quarterly Adjustment) and interactive transaction modes. The table given below describes the parameters used to control messaging and the figure below shows the Change Message Control for Trillium window with the appropriate settings defined.
|
Setting |
Values |
Description |
|
MsgNo |
Read Only |
An error message number returned by the RFC call from Trillium Quality. These values are fixed numbers based on the Postal Match Level code and cannot be changed in the IMG table. Numbers starting with 00x are messages for Street Address section. Numbers starting with 01x are messages for PO Box address section. |
|
Message text |
Text |
The message text displayed when the error is encountered. |
|
User Name |
Blank |
Blank. Not currently used. |
|
Online |
I,W,E,S, - |
Specifies how the relevant TS Connector system message is treated by the system for online input, where: I = Information/note in window W = Warning E = Error S = Note in footer - = Switch off message. |
|
Batchl |
I,W,E,S, - |
Specifies how the relevant TS Connector system message is treated by the system for batch input (Quarterly Updates), where: I = Information/note in window W = Warning E = Error S = Note in footer - = Switch off message. |
|
Standard |
I,W,E,S, - |
System requirement for a standard type (default value) with which to output the message if there are no individual settings in the Online or Batch, where: I = Information/note in window W = Warning E = Error S = Note in footer - = Switch off message. |
