MFXOPT Messages - mfx - 3.1

MFXOPT COMPLETED SUCCESSFULLY   

EXPLANATION: The MFXOPT command was executed success­fully. No errors were encountered.   

MFXOPT FAILED   

EXPLANATION: Errors were encountered during MFXOPT processing. Refer to the MFXOPT WER8nnA message for more information.

MFXOPT: PARAMETER ERROR   

EXPLANATION: The START MFXOPT command contained invalid syntax or required parameters were missing.

MFXOPT: MFX ECSA ENTRY MISMATCH FOUND   

EXPLANATION: This is an internal error. Contact Precisely Support. 

MFXOPT:  PARMLIB ERROR RETCODE=          ,REASON CODE=

EXPLANATION: The PARMLIB data sets could not be allocated, and MFXOPT processing was not completed.

MFXOPT: CANNOT FIND/LOAD SYNCMAC MODULE   

EXPLANATION: This can be caused by any of the following reasons:

1. Dynamic allocation of a DD failed for the SYNCMAC module.
2. The load module name specified in MFXPRMxx cannot be found.
3. The load module cannot be opened.   

MFXOPT: PARMLIB SYNCMAC MODULE ERROR   

EXPLANATION: The load module name specified in the MFX­PRMxx member is not a SYNCMAC module.   

STORAGE NOT AVAILABLE IN PRIVATE AREA   

EXPLANATION: MFXOPT could not complete processing because there was insufficient space in the system private area.

MFXOPT: STORAGE NOT AVAILABLE IN ECSA   

EXPLANATION: MFXOPT could not complete processing because there was insufficient space in the ECSA.

PARMLIB SYNCMAC FOR RELEASE xx HAS BEEN DEACTIVATED   

EXPLANATION: MFXOPT completed the deactivation of the specified release’s MFXPRM member. Options from the MFX load libraries will be in effect instead of the MFXPRM member load library.   

MFXOPT: PARMLIB SYNCMAC FOR RELEASE xx CANNOT BE FOUND  

EXPLANATION: The PARMLIB SYNCMAC options for r.r in the MFXPRM=’DEACT,r.r’  parameter cannot be found in the ECSA area. You can use the DISP parameter to view the source location of the active PARMLIB SYNCMAC on this system. 

PARAMETER ERROR: INCORRECT RELEASE   

EXPLANATION: The r.r in the MFXPRM=’ACT,xx,r.r’ parameter is incorrect and not supported by MFXOPT. 

MFXOPT: TOO MANY PARMLIB RELEASES 

EXPLANATION: MFXOPT only supports four MFX releases on one system. You can use the DISP parameter to display the numbers of the MFX releases with MFXPRM members and use the DEACT parameter to deactivate MFXPRM members for old MFX releases.

INSTALLATION OPTIONS IN xxxxxxxx WILL BE USED   

EXPLANATION: This message indicates the location of the default installation options in effect.   xxxxxxxx will indicate a PARMLIB member or the MFX load library.

MFXPRMG CAN ONLY BE EXECUTED FROM A START MFXOPT COMMAND   

EXPLANATION: This is a WTO message; MFXPRMG was not invoked by a START MFXOPT command.

MFXOPT:   RELEASE    MFXPRM rel   MFXPRMxx IN yyyyyy

EXPLANATION: This is an informational message issued when the DISP parameter is used. The source location of the default installation options in effect will be displayed. rel is the release number of MFX; yyyyyy is the name of the data set specified in the MFXPRMxx member.