Stop CONNECTCDC - Connect_CDC - aws_mainframe_modernization_service - connect_cdc_mimix_share - 6.x

Connect CDC Getting Started Guide

Product type
Software
Portfolio
Integrate
Product family
Connect
Product
Connect > Connect CDC (MIMIX Share)
Version
6.x
Language
English
Product name
Connect CDC
Title
Connect CDC Getting Started Guide
Copyright
2024
First publish date
2003
Last updated
2024-10-15
Published on
2024-10-15T20:38:41.117981

To stop the subsystem, do the following:

  1. In Connect CDC MonCon, stop the Change Selector.

  2. Stop the Connect CDC Listener (see the IBM i Installation Guide for more information).

  3. Stop the subsystem:

ENDSBS SBS(CONNECTCDC) OPTION(*IMMED) DELAY(10)

Note that if the Change Selector is started with the CONNECTCDC subsystem (see Start Change Selector Automatically with the CONNECTCDC Subsystem) and is manually stopped and started using Connect CDC MonCon or Connece CDC Console, the Change Selector will not start in the CONNECTCDC subsystem automatically. Instead, the Change Selector will be started in the default batch subsystem because the monitoring and control tools use the OMNIREP job description that exists in the Connect CDC install library. To start the Change Selector from the CONNECTCDC subsystem if this occurs, do the following:

  1. Modify the CONNECTCDC jobd in the install library. From the CHANGE JOB DESCRIPTION (CHGJOBD) menu, change the job queue to CONNECTCDC and the library to your Connect CDC library where you installed the Change Selector:   

  2. Using the CHGJOBD command make this jobd point to the CONNECTCDC jobq owned by the CONNECTCDC subsystem:

    CHGJOBD JOBD(..../CONNECTCDC) JOBQ(.../CONNECTCDC)

  3. Increase the maximum number of jobs in the CONNECTCDC job queue to nomax. It is currently set to 1. You can do this with:

CHGJOBQE SBSD(..../CONNECTCDC) JOBQ(.../CONNECTCDC MAXACT(*NOMAX)

This example uses the library SHARE570;

Before:

JOB DESCRIPTION  . . >    OMNIREP    NAME                    LIBRARY  . . . . . . >    SHARE570    NAME, *LIBL,*CURLIB  JOB QUEUE  . . . . . >    QSYSNOMAX    NAME, *SAME           LIBRARY  . . . . . . >    QSYS           NAME, *LIBL, *CURLIB  

After:

JOB DESCRIPTION  . . >   OMNIREP    NAME                     LIBRARY  . . . . . . >    SHARE570    NAME, *LIBL, *CURLIB  JOB QUEUE  . . . . . >    CONNECTCDC        NAME, *SAME           LIBRARY  . . . . . . >    SHARE570    NAME, *LIBL, *CURLIB  

You can now manually start the Change Selector in the CONNECTCDC subsystem. If you are unable to start the CONNECTCDC subsystem, verify that the library the CONNECTCDC subsystem started is correct and matches what you are specifying in the JOB DESCRIPTION.

WRKSBSD SBSD(SHARE570/CONNECTCDC)option 5:  displayverify the status is active                                    DISPLAY SUBSYSTEM DESCRIPTIONSUBSYSTEM DESCRIPTION:CONNECTCDC    LIBRARY:SHARE570STATUS:   ACTIVE