To access the list of replicated jobs on a system, do one of the following from the native user interface:
-
Enter the command:
WRKREPJOB -
Use option 59 (Replicated jobs) from one of the following displays:
-
Work with Application Groups display (WRKAG command)
-
Work with Data Rsc. Grp. Ent. display (WRKDTARGE command)
-
Work with Data Groups display (WRKDG command)
-
When the local system is the current target system, the Work with Replicated Jobs display lists the jobs that have been replicated to this system. You can use options to remove or run a job on the current target node if needed.
When the local system is the current source system, the display lists the jobs that were replicated to the system prior to the last switch (when the local system was then the target). These jobs did not complete on the originating system before the time of the last switch. Evaluate these jobs and either submit them to run on the local system (the new source) or remove them before the data group is switched again. If the jobs remain on the current source system, they are a condition that will prevent a planned switch.