If you receive errors when using a target journal defined by an RJ link, you may need to change the journal definition and journaling environment. This situation is caused when the target journal definition is created as a result of adding an RJ link based on a source journal definition which specified QSYSOPR as the threshold message queue.
If you receive errors when using the target journal, do the following:
-
On the Work with Journal Definitions display, locate the target journal definition that is identified by the errors.
-
Type a 5 (Display) next to the target journal definition and press Enter.
-
Page down to see the value of the Threshold message queue.
-
If the value is QSYSOPR, press F12 and continue with the next step.
-
For any other value, the cause of the problem needs further isolation beyond this procedure.
-
-
Type a 2 (Change) next to the target journal definition and press Enter.
-
Press F9 (All parameters), then page down to locate the Threshold message queue and Library prompts.
-
Change the Threshold message queue prompt to *JRNDFN and the Library prompt to *JRNLIB, or to other acceptable values.
-
To accept the change, press Enter.