Removing unconfirmed entries to free an RJ link - assure_mimix - 10.0

If you need to remove a backlog of unconfirmed entries, do the following:

1. Use the WRKRJLNK command to display the status of the RJ link. The status shown on the Work with RJ Links display is the status of the link on the system where you entered the command. (This system is identified at the upper right corner of the display.) An RJ link with unconfirmed entries will have a state of *INACTPEND.

   Note: You may need to access this display from the other system defined by the RJ link.

2. Ending the remote journal link on the system with unconfirmed entries will cause them to be deleted. Do the following:

   1. Type 10 (End) next to the link and press F4 (Prompt).
   2. The End Remote Journal Link (ENDRJLNK) display appears. Default values on this command ends the link from the source system. If there are unconfirmed entries on the target system, press F10 (Additional parameters). Then specify *TGT at the End RJ link on system prompt.
   3. To process the request, press Enter.