For an application group, a procedure for only one operation (start, end, or switch) can run at a time. For information about parameters and shipped procedures, see What is ended by the default END procedure for an application group and Choices when starting or ending an application group.
To end an application group, do the following:
From the Work with Application Groups display, type
10(End) next to the application group you want and pressF4(Prompt).Verify that the values you want are specified for Resource groups and Data resource group entry.
If you are starting the procedure after addressing problems with the previous end request, specify the value you want for Begin at step. Be certain that you understand the effect the value you specify will have on your environment.
Press Enter.
The Procedure prompt appears. Do one of the following:
-
To use the default end procedure, press Enter.
-
To use a different end procedure for the application group, specify its name. Then press Enter.
-