For most configurations, It is recommended that you end MIMIX products from the management system, which is usually the backup system. If your installation is configured so that the backup system is a network system, you should end MIMIX from the network system.
Notes:
If you are ending MIMIX for a software upgrade or to install a service pack, use the procedures in the software’s ReadMe document.
The ENDMMX command cannot run when application groups are configured and there are any active, failed, or canceled procedures.
Determine whether you also need to end RJ links. See When to end RJ links.
To end MIMIX, use the following procedures:
Use one of the following procedures:
Complete any needed follow-up actions using the information and procedures in After you end MIMIX products.