The data group definition determines the behavior for replicating user profile status unless it is explicitly overridden by a non-default value in a data group object entry. The value determined after the order of precedence is resolved is sometimes called the overall MIMIX configuration value. Unless specified otherwise in the data group or in an object entry, the default is to use the value *SRC from the data group definition. Table 164 shows the possible values at both the data group and object entry levels.
|
*DGDFT |
Only available for data group object entries, this indicates that the specified in the data group definition is used for the user profile statue. This is the default value for object entries. |
|
*DISABLE 1 |
The status of the user profile is set to *DISABLED when the user profile is created or changed on the target system. |
|
*ENABLE 1 |
The status of the user profile is set to *ENABLED when the user profile is created or changed on the target system. |
|
*SRC |
This is the default value in the data group definition. The status of the user profile on the source system is always used when the user profile is created or changed on the target system. |
|
*TGT |
If a new user profile is created, the status is set to *DISABLED. If an existing user profile is changed, the status of the user profile on the target system is not altered. |
|
1Data group definitions use these values. In data group object entries, the values *DISABLED and *ENABLED are used but have the same meaning. |